How to connect Molex

Discussion in 'General Electronics Chat' started by nikomas, May 24, 2011.

  1. nikomas

    Thread Starter New Member

    Mar 31, 2010
    Hello all.

    I have a module that interfaces via Molex 53748-0708 connector (Link).

    What is the best way to connect it to my PCB?
    I guess this is the pairing connector: Link,
    but i dont have a clue about what cable to use, how does it attach to the connector, or how to solder this connector to my PCB since it is extra tiny...

    Any ideas?
    (Is there maybe a solution where a cable uses different connectors on both ends?)

    Thanks in advance!!