It looks like no one has asked you to post the make and model of the machine. Can you do that?

Ken

Yea, so someone experienced in repairing washing machines might be able to get schematics for you.

Allen

 

Yeah id imagin if it was a heater it would trip mid cycle
Usualy interlock would be to blame but swaped that and still didn't work.
The washer is sw2011w old swan washer.

 

Yeah id imagin if it was a heater it would trip mid cycle
Usualy interlock would be to blame but swaped that and still didn't work.
The washer is sw2011w old swan washer.

Not if you fill it with cold water and expect it to heat it...…….

 

Usualy interlock would be to blame but swaped that and still didn't work.

If you swapped instead of probing/measuring the interlock health; there is maaaany more components to swap daily for a year until you guess the bad one.

 

The heater doesnt kick in straight away washes cold for a bit then heats Obvestly I dont no if the board is reading the health of the thermostat and eliment id imagin not untill its activated in the cycle.
Usualy when they are bad it just doesnt heat or trips electric mid cycle
Motor again It wouldn't stop it from starting.just wouldnt spin.
Drain pump wouldnt stop it starting
The board just activates and stops it.
The board am certain is the issue the chip I mentioned.
Will replace it and see if it works.
Thanks for replys any thoughts are welcome.
Was just thinking could a pressure switch stop it working but it would duly still need to start and fill before its activated.