Am working with an optical isolator (ISO). My ISO source side (8051) is 5v +- and working properly. However, my load side only works with no load.
Load side... 4 C batteries (just over 6v), when I run this with resistor, transistor and no load, my output is 5.83v.. (thats ok). But I get 2mA...
How can I raise the output current to 330mA min - 380mA max from the output connection?
Am trying to hook up a motor with the above minimum current requirement
The motor works with direct connect to batteries, but you already knew that.
Any help or op-amp design submission would be greatly appreciated...
Thank you
Load side... 4 C batteries (just over 6v), when I run this with resistor, transistor and no load, my output is 5.83v.. (thats ok). But I get 2mA...
How can I raise the output current to 330mA min - 380mA max from the output connection?
Am trying to hook up a motor with the above minimum current requirement
The motor works with direct connect to batteries, but you already knew that.
Any help or op-amp design submission would be greatly appreciated...
Thank you