Hello,
i am trying to repair an Enecsys SMI 480-60 Solar inverter.
I was looking for a schematic on the internet for quit a long time and finally found a schematic on this forum wich is very great.
This thread: https://forum.allaboutcircuits.com/threads/solar-micro-inverter-power-management.134979/
I inspected the unit en found no burned components, the fuse is ok and there are no short-circuited power mosfets.
This inverter behaves as follows when it is connected to the 220 volts and the solar panels are connected:
- on a properly functioning inverter, the yield of these panels is approximately 31 watts just before conversion;
- on the enecsys inverter everything stays at 0 for about 2 minutes;
- after about 2 minutes, my power meter indicates 2 watts as yield (or decrease) and about 41 VA (apparent power);
- shortly afterwards everything goes back to 0 and it stays that way.
It looks like the DC circuit is okay and there is an error somewhere that shuts things down.
I hope someone can point me in a direction to track down and fix this error?
i am trying to repair an Enecsys SMI 480-60 Solar inverter.
I was looking for a schematic on the internet for quit a long time and finally found a schematic on this forum wich is very great.
This thread: https://forum.allaboutcircuits.com/threads/solar-micro-inverter-power-management.134979/
I inspected the unit en found no burned components, the fuse is ok and there are no short-circuited power mosfets.
This inverter behaves as follows when it is connected to the 220 volts and the solar panels are connected:
- on a properly functioning inverter, the yield of these panels is approximately 31 watts just before conversion;
- on the enecsys inverter everything stays at 0 for about 2 minutes;
- after about 2 minutes, my power meter indicates 2 watts as yield (or decrease) and about 41 VA (apparent power);
- shortly afterwards everything goes back to 0 and it stays that way.
It looks like the DC circuit is okay and there is an error somewhere that shuts things down.
I hope someone can point me in a direction to track down and fix this error?