Ok , so I am learning how to use eagle software to design my own PCB boards.
But when I am done with the scheme .sch file I then save it and click the board icon to generate the board.
It does it but when I look at the components some of them are missing connections to one another can somebody look and see what I am missing. ( tried to put in a ton of junctions to remedy this problem but some of the components seem to have holes where wires should be out of them)
Also how do you get the components on the side of the board to move into the square for the .brd file???
I am shakey on how to work with the board file to create my PCB design?
Thanks for any help
attached is the .sch file and the .brd file (however you can generate the .brd by the .sch )
The orginal circuit I was trying to copy for practice was
http://www.reconnsworld.com/transmit/fm_trasm.gif <--(fabricating a simple FM transmitter circuit )
But when I am done with the scheme .sch file I then save it and click the board icon to generate the board.
It does it but when I look at the components some of them are missing connections to one another can somebody look and see what I am missing. ( tried to put in a ton of junctions to remedy this problem but some of the components seem to have holes where wires should be out of them)
Also how do you get the components on the side of the board to move into the square for the .brd file???
I am shakey on how to work with the board file to create my PCB design?
Thanks for any help
attached is the .sch file and the .brd file (however you can generate the .brd by the .sch )
The orginal circuit I was trying to copy for practice was
http://www.reconnsworld.com/transmit/fm_trasm.gif <--(fabricating a simple FM transmitter circuit )
Attachments
-
109.1 KB Views: 27
-
8.3 KB Views: 16
Last edited: