I have been given a heart pump which consists of a dual stator, three phase motor. I wasn't given much information about the motor apart from the fact that it has four poles and two stators - one above and one below an internal impeller for blood pumping.
I have been asked to make it spin but I need a controller to do this. Hence I need more information about the motor, i.e. its connection type (Y or delta) as well as matching the top wires with the bottom.
The device has six wires coming from it (black, yellow, green, blue, red, white). I am assuming that because after a continuity test, the black, green, and red wires make up one stator and the yellow, blue and white wires make up the other (as they are connected).
My question is: Is there a way to determine the configuration of the stators and possibly, if I can match up the top to the bottom so I can make it spin?
I have been asked to make it spin but I need a controller to do this. Hence I need more information about the motor, i.e. its connection type (Y or delta) as well as matching the top wires with the bottom.
The device has six wires coming from it (black, yellow, green, blue, red, white). I am assuming that because after a continuity test, the black, green, and red wires make up one stator and the yellow, blue and white wires make up the other (as they are connected).
My question is: Is there a way to determine the configuration of the stators and possibly, if I can match up the top to the bottom so I can make it spin?