I need to build a split rail converter with 24V in and +15V, -15V out. There are not a lot of converter modules with this configuration however in the past I have succeeded by putting two 24->15 converters back to back sharing a common ground. (I don't want to start from scratch and build a converter but prefer to assemble with commercial modules)
I would like to insure best practices here, and wonder if there is a "gotcha" document discussing any problems or procedures with this type of design.
Any comments appreciated
thanks
Fritz
I would like to insure best practices here, and wonder if there is a "gotcha" document discussing any problems or procedures with this type of design.
Any comments appreciated
thanks
Fritz