Hi everyone!

I'm designing my first two layer circuit board with eagle and I was hoping some people could look it over and give me any tips on changes before I send it off to get produced.

The board will act like a shield, sitting on the Arduino DUE and is essentially a board made up of JST and other connectors which will make my life easier when it comes to putting my project together. I've placed all the connectors about where I want them and I'm fine with some of them sticking out on the left/right side.

Let me know what you all think!

Download the files here (right-click; save link as...):
board
schematic

 

Please upload the files as .brd and .sch. You can do this by clicking the "go advanced" tab and selecting "attach". It will make it much easier for us to download/access them.

Once you've uploaded the files directly, we'll go from there

Regards,
Matt