This dish washer motor runs on 120 V 60Hz at 1.7A (you can read the rest from the sort of blurry picture)
It has two wires that appear to bring power in (120VAC) and three smaller wires that must control speed.
I'd like to set it up to run a fountain sometime in the future. But to use it - I can't just throw 120 VAC on it. Something controls speed. The shaft rotates like a stepper motor with 18 definite stop positions.
Any help?
VSM - U2 306466
Electronically Protected
BLDC checked
04.03.2011 - - - - - 06:48
AWECO 305792 VSM-U2-xx E302296
730.50003.02 S 063.11 III. 2349 444
120V 60 Hz 1.7A 95W C1. F
For use with max. 75'C Water
Max. surr. air 60'C HW01 SW7.06
It has two wires that appear to bring power in (120VAC) and three smaller wires that must control speed.
I'd like to set it up to run a fountain sometime in the future. But to use it - I can't just throw 120 VAC on it. Something controls speed. The shaft rotates like a stepper motor with 18 definite stop positions.
Any help?
VSM - U2 306466
Electronically Protected
BLDC checked
04.03.2011 - - - - - 06:48
AWECO 305792 VSM-U2-xx E302296
730.50003.02 S 063.11 III. 2349 444
120V 60 Hz 1.7A 95W C1. F
For use with max. 75'C Water
Max. surr. air 60'C HW01 SW7.06