Hello Everyone.
I'd like to start by saying that my electronics knowledge is very very limited... But i'm very quick to understand concepts and theories.
Im currently building a circuit using a Murata okr-t6-w12 - Data sheet is on-line if you search for it. (not sure if noobs can post links)
Its a DC-DC Voltage Converter and on the datasheet is states the following resistances needed to obtain the output voltages.
The range i am interested in (with its related resistance levels) Is Highlighted in BOLD Below:
6 V. - 218.5 Ohms
5 V. - 268 Ohms
3.3 V. - 436 Ohms
2.5 V. - 619 Ohms
1.8 V. - 978 Ohms
1.5 V. - 1300 Ohms
I need a digital pot that can help me achive these figures without going too far either side of them.
Also ideally i would like it to have as many steps as needed in order to adjust the voltages by 0.1v with each click. Otherwise it can be 0.05v per click.
Can anyone please assist me in working out what exactly i should be looking for?
Many thanks
I'd like to start by saying that my electronics knowledge is very very limited... But i'm very quick to understand concepts and theories.
Im currently building a circuit using a Murata okr-t6-w12 - Data sheet is on-line if you search for it. (not sure if noobs can post links)
Its a DC-DC Voltage Converter and on the datasheet is states the following resistances needed to obtain the output voltages.
The range i am interested in (with its related resistance levels) Is Highlighted in BOLD Below:
6 V. - 218.5 Ohms
5 V. - 268 Ohms
3.3 V. - 436 Ohms
2.5 V. - 619 Ohms
1.8 V. - 978 Ohms
1.5 V. - 1300 Ohms
I need a digital pot that can help me achive these figures without going too far either side of them.
Also ideally i would like it to have as many steps as needed in order to adjust the voltages by 0.1v with each click. Otherwise it can be 0.05v per click.
Can anyone please assist me in working out what exactly i should be looking for?
Many thanks