Hello,
Have been searching the web for quite some time but to no avail. Recently ran into your forum and thought to run it by the people here. Have formal machine design education but next to none concerning electric except for basic equations.. The mechanical aspects are fairly worked out and i only need help/suggestions concerning heating a plate thru which cold air flows on it's course to the face mask.This plate is designated as number "3" in the drawing. Not sure rather to simply thread nichrome coated wire thru said plate #3 or attach a power resister of which i have no idea how to do. mask has a one way outlet valve
At present i have
1. temperature controller.
2.sensor to warn me when my battery falls below a certain voltage.
3.5000mAh 11.1 volts battery-rechargeable Lipo Pack
and of course a multimeter
I can machine aluminum.
The entire project is of aluminum. inside mask temperature should be 60-75f which i think to control with the temp troller regardless of any normal outside temperature differentiation?
Thanx for any time, suggestions or critique
ps links could be given to the components but not sure rather it would be appropriate here.
Have been searching the web for quite some time but to no avail. Recently ran into your forum and thought to run it by the people here. Have formal machine design education but next to none concerning electric except for basic equations.. The mechanical aspects are fairly worked out and i only need help/suggestions concerning heating a plate thru which cold air flows on it's course to the face mask.This plate is designated as number "3" in the drawing. Not sure rather to simply thread nichrome coated wire thru said plate #3 or attach a power resister of which i have no idea how to do. mask has a one way outlet valve
At present i have
1. temperature controller.
2.sensor to warn me when my battery falls below a certain voltage.
3.5000mAh 11.1 volts battery-rechargeable Lipo Pack
and of course a multimeter
I can machine aluminum.
The entire project is of aluminum. inside mask temperature should be 60-75f which i think to control with the temp troller regardless of any normal outside temperature differentiation?
Thanx for any time, suggestions or critique
ps links could be given to the components but not sure rather it would be appropriate here.
Attachments
-
77.5 KB Views: 36
Last edited: