im working on a project that is using a parallel capacitor bank made of four 400V 6300uf caps. im going to use a 120V outlet as the power source and my problem and question are this: as it is, according to pspice, it will take roughly forever for the bank to reach its 400V from the CW multiplier circuit i made. is there any ways to significantly reduce the time to get fully charge or perhaps a different method for stepping up the voltage i could use?

 

Hello,

I am closing this thread as it violates AAC policy and/or safety issues.

Quote:
6. Restricted topics. The following topics are regularly raised however are considered “off-topic” at all times and will results in Your thread being closed without question:

Any kind of over-unity devices and systems
Automotive modifications
Devices designed to electrocute or shock another person
LEDs to mains
Phone jammers
Rail guns and high-energy projectile devices
Transformer-less power supplies

This comes from our Tos:
Terms of Service

Bertus