Has anyone done this successfully?
I tried, using AH49E sensors which work perfectly with an external jig powered with an external 4.5 V supply. However, when connected to the joystick pot sockets, duly observing the swapping of Pin2, (middle) and Pin3, (right side, bevelled face up, pins down), it does not work.
Grateful for your advice or solution.
I tried, using AH49E sensors which work perfectly with an external jig powered with an external 4.5 V supply. However, when connected to the joystick pot sockets, duly observing the swapping of Pin2, (middle) and Pin3, (right side, bevelled face up, pins down), it does not work.
Grateful for your advice or solution.
