Hi, was just wondering if anyone could help.
This is a university project i have been given. Im very unexperienced in this area of electronics so i am really struggling, especially with the measurements and calculations side of the experiment. Here is the basics of the assessment.
You are required to produce a report detailing how you would construct and test an electronic circuit.
You need to detail a circuit comprising of a resistor of 1 KΩ and a capacitor to produce:
(i) a first-order low pass filter with a cut off frequency of 2.5KHz
(ii) a first order high pass filter with a cut off frequency of 4KHz
You are required to produced a circuit diagram for each case, and calculate the value of the capacitor required to meet the frequency response requirements stated.
This may seem like an easy task, but as i said i have absolutely no experience with this and find it difficult to state the measurements and calculations needed due to the fact i am not actually taking part in the experiment, only writing a report about it.
If anyone could help or point me in the right direction i will be very grateful,
thanks for your time
This is a university project i have been given. Im very unexperienced in this area of electronics so i am really struggling, especially with the measurements and calculations side of the experiment. Here is the basics of the assessment.
You are required to produce a report detailing how you would construct and test an electronic circuit.
You need to detail a circuit comprising of a resistor of 1 KΩ and a capacitor to produce:
(i) a first-order low pass filter with a cut off frequency of 2.5KHz
(ii) a first order high pass filter with a cut off frequency of 4KHz
You are required to produced a circuit diagram for each case, and calculate the value of the capacitor required to meet the frequency response requirements stated.
This may seem like an easy task, but as i said i have absolutely no experience with this and find it difficult to state the measurements and calculations needed due to the fact i am not actually taking part in the experiment, only writing a report about it.
If anyone could help or point me in the right direction i will be very grateful,
thanks for your time