CC2500 and ATmega8 using SPI

Discussion in 'Embedded Systems and Microcontrollers' started by RollNOThree, Sep 3, 2013.

  1. RollNOThree

    Thread Starter New Member

    Sep 3, 2013
    M interfacing CC2500 with AVR via SPI
    while configuring if I send the status byte received on port, I can see some changes signifying modules are working
    Configuration bytes I have used are the one provided by chipcon in some sample code
    but after config no data is received or transmitted...
    If anyone can guide me with working on CC2500!!