By using regulating IC LM317 I had wanted to get an output of 9volts Dc by inputting 19.54DC as shown by the configuration below
This configuration gave an output of 7.54 volts DC. But yesterday I changed the electrolytic capacitor which was 10µF 25v to 3300µF 35v and I get 8.61 volts DC output, except that the LED died few seconds during the process. I want to know what component to change; the component value or the component it self to get an output of 9volts. And also if my circuit diagram is correct for this job. Thank you
This configuration gave an output of 7.54 volts DC. But yesterday I changed the electrolytic capacitor which was 10µF 25v to 3300µF 35v and I get 8.61 volts DC output, except that the LED died few seconds during the process. I want to know what component to change; the component value or the component it self to get an output of 9volts. And also if my circuit diagram is correct for this job. Thank you
Attachments
-
6.7 KB Views: 3