Hi everyone,
I'm sorry for posting right in here, all my keywords are creating such a mass of hits its making it near possible to filter out what i'm trying to achieve.
its quite a monstrous task and I want to do as much research I can myself but if I could get some directions or link from the witty people on this forum id be every thankful.
I am trying to basically 'build' a very low resolution LED display (TV if you will) about 50cm x 50cm. I'm hoping to be ambitious and get 1000 led's (250 x RBGY) in this area.
So there are lots of questions around this
How to manufacture the SMD/LEDs, PCB's and Micro Controllers (and which ones to use)
How to project the image from a source through (???) to the LED's.
I've seen images of it being done, I'm just not sure where to start.
I have some basic electronic experience studying at TAFE but that was many years ago. Also once upon a time I was a jeweler and have picked up quite the steady hand and an eye for detail, not to mention patience.
I am aware this will
1) be expensive
2) take a very long time and
3) both of the above
The panel will need to be manufacture/fabricated because the result i'm after will not be flat.
If anyone can advise my or point me to some information regarding any of my queries I will be forever thankful.
Many thanks in advance,
Dayle
I'm sorry for posting right in here, all my keywords are creating such a mass of hits its making it near possible to filter out what i'm trying to achieve.
its quite a monstrous task and I want to do as much research I can myself but if I could get some directions or link from the witty people on this forum id be every thankful.
I am trying to basically 'build' a very low resolution LED display (TV if you will) about 50cm x 50cm. I'm hoping to be ambitious and get 1000 led's (250 x RBGY) in this area.
So there are lots of questions around this
How to manufacture the SMD/LEDs, PCB's and Micro Controllers (and which ones to use)
How to project the image from a source through (???) to the LED's.
I've seen images of it being done, I'm just not sure where to start.
I have some basic electronic experience studying at TAFE but that was many years ago. Also once upon a time I was a jeweler and have picked up quite the steady hand and an eye for detail, not to mention patience.
I am aware this will
1) be expensive
2) take a very long time and
3) both of the above
The panel will need to be manufacture/fabricated because the result i'm after will not be flat.
If anyone can advise my or point me to some information regarding any of my queries I will be forever thankful.
Many thanks in advance,
Dayle
Last edited by a moderator: