All About Circuits

Brake chopper and gate drive

A

Thread Starter

andreaschar90

Joined Nov 8, 2011
13
How can I connect a brake chopper to a gate drive?
As my understanding the brake chopper needs a PWM signal from the gate drive to operate. But i do not know at which pin of the gate drive the mosfet of the brake chopper has to be connected. The gate drive I use is the HIP4081A. Do I have to use different gate drive for the brake chopper?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
C I would be extremely grateful if someone could point me in the right direction on building a safe/reliable circuit for my bikes brake light. Analog & Mixed-Signal Design 7
J vehicle - filter out brake signal. Analog & Mixed-Signal Design 7
CSspeed225 Turn Signal/Brake Light/Hazard Circuit Analog & Mixed-Signal Design 15
mario raffin Brake actuator for stepper motor Analog & Mixed-Signal Design 0
A Brake chopper control algo Power Electronics 3
Similar threads
I would be extremely grateful if someone could point me in the right direction on building a safe/reliable circuit for my bikes brake light.
vehicle - filter out brake signal.
Turn Signal/Brake Light/Hazard Circuit
Brake actuator for stepper motor
Brake chopper control algo

You May Also Like

Top