I'm trying to build some inline audio pads the type that's built in a XLR to XLR turnaround connector How do I go about what resistor value and across which pins of the XLR connector to I solder the resistors. I'd like to build -20, -30 and -50 audio pas to attenuate a line level audio signal.
Hello, in the following PDF-file you have the circuits for the attenuation of 20dB, 30dB and 50 dB. http://www.rainers-elektronikpage.de/Andere_Foren/Abschwaecher_600_Ohm.pdf Regards Rainer PS: Sorry, if my English is not so good.