I have designed a schematic and PCB which has 2 H-bridge drivers using the Allegro A3941 full bridge MOSFET driver.
I am having problems when changing the PHASE of the H-bridge, because excessive noise appears on the control inputs (PWMH, PWML, PHASE) which causes the H-bridges to erratically turn on and off.
I am only using the PWMH and PHASE control inputs. With reference to the attached schematic, the DIP switches are configured as follows:
SW1&2a - PWMH and PWML short = OFF
SW1&2b - PWMH 47k pull down resistor = ON
SW1&2c - PWML 47k pull up resistor = ON
SW1&2d - PHASE 47k pull down resistor = ON
SW1&2e - SYNCHRONOUS RECTIFICATION 47k pull up resistor = ON
Therefore the driver is configured for the "slow decay, SR active, high-side PWM" mode.
The circuit behaves correctly when the PHASE input is LOW (0V) but behaves erratic when the PHASE input is HIGH (5V).
The PCB is a 4 layer board and each layer is attached for reference, in addition to the Bill of Materials.
Can anyone offer any suggestions what the issue could be ?
Before using this PCB I designed, I was using the "Pololu High-Power Motor Driver 18v25 CS" which worked without any issues. The Pololu driver uses the same Allegro A3941 driver and has the same pull up and pull down resistors on the control inputs.
I am having problems when changing the PHASE of the H-bridge, because excessive noise appears on the control inputs (PWMH, PWML, PHASE) which causes the H-bridges to erratically turn on and off.
I am only using the PWMH and PHASE control inputs. With reference to the attached schematic, the DIP switches are configured as follows:
SW1&2a - PWMH and PWML short = OFF
SW1&2b - PWMH 47k pull down resistor = ON
SW1&2c - PWML 47k pull up resistor = ON
SW1&2d - PHASE 47k pull down resistor = ON
SW1&2e - SYNCHRONOUS RECTIFICATION 47k pull up resistor = ON
Therefore the driver is configured for the "slow decay, SR active, high-side PWM" mode.
The circuit behaves correctly when the PHASE input is LOW (0V) but behaves erratic when the PHASE input is HIGH (5V).
The PCB is a 4 layer board and each layer is attached for reference, in addition to the Bill of Materials.
Can anyone offer any suggestions what the issue could be ?
Before using this PCB I designed, I was using the "Pololu High-Power Motor Driver 18v25 CS" which worked without any issues. The Pololu driver uses the same Allegro A3941 driver and has the same pull up and pull down resistors on the control inputs.
Attachments
-
162.9 KB Views: 199
-
546.7 KB Views: 76
-
557.3 KB Views: 50
-
555.1 KB Views: 39
-
534.3 KB Views: 47
-
44 KB Views: 55
Last edited: