Hello everyone,
I was swapping out my laptop battery and accidently pulled too hard on the port when trying to disconnect it and it ripped out of the motherboard. Looking for suggestions on how I should go about repairing this. I have a Weller soldering iron, and as a current college student I have access to a soldering lab. Any information resources or links to products I would need would be greatly appreciated. I'm also in the Buffalo area, if any of you happen to know of someone capable of this kind of repair.
The laptop turns on, its just no longer a laptop but a desktop since it must be plugged in at all times.
(Motherboard is $750 so I'd rather not replace it)
I was swapping out my laptop battery and accidently pulled too hard on the port when trying to disconnect it and it ripped out of the motherboard. Looking for suggestions on how I should go about repairing this. I have a Weller soldering iron, and as a current college student I have access to a soldering lab. Any information resources or links to products I would need would be greatly appreciated. I'm also in the Buffalo area, if any of you happen to know of someone capable of this kind of repair.
The laptop turns on, its just no longer a laptop but a desktop since it must be plugged in at all times.
(Motherboard is $750 so I'd rather not replace it)
Attachments
-
3.7 MB Views: 35
-
4 MB Views: 35