ADC0804

Reply to Thread

Discussion in 'Homework Help' started by bonez2, Apr 28, 2005.

Reply to Thread
  1. Apr 28, 2005 #1
    bonez2

    Thread Starter New Member

    Apr 28, 2005
    1
    0
    How does a microprocessor tell an ADC0804 to place a result in the data bus?

    and how does it know when the ADC0804 has finished a conversion and its data are valid?


    Please help, I would really appriciate anybodys help....

    Thank You
     
    #1 Reply
  2. May 1, 2005 #2
    beenthere

    Retired Moderator

    Apr 20, 2004
    15,815
    290
    Hi,

    Most converters are considerate and generate an EOC (end of conversion) signal. That lets the microprocessor know to grab the data and get on with things. If there's no EOC from the ADC084, then there's no way to know when the data are valid.
     
    #2 Reply
Loading...
Related Forum Posts:
  1. TAKYMOUNIR

    Adc0804,dac0808

    Posted by TAKYMOUNIR in forum: Homework Help
    Replies:
    4
    Views:
    1,494
  2. keafeel

    ADC0804 as 4bit ADC

    Posted by keafeel in forum: General Electronics Chat
    Replies:
    1
    Views:
    1,260
  3. jag1972

    Adc0804

    Posted by jag1972 in forum: Embedded Systems and Microcontrollers
    Replies:
    0
    Views:
    966
  4. kachung30

    interfacing ADC0804 to 89c51

    Posted by kachung30 in forum: Embedded Systems and Microcontrollers
    Replies:
    3
    Views:
    2,965
  5. Infinity1

    ADC0804

    Posted by Infinity1 in forum: Programmer's Corner
    Replies:
    7
    Views:
    3,044
  6. ohorit

    interfacing adc0804

    Posted by ohorit in forum: General Electronics Chat
    Replies:
    3
    Views:
    3,724
You May Also Like:

  1. Servo Control with Arduino Through MATLAB

  2. Beyond the DMM: Components and Circuits for Measuring Current and Voltage

  3. Introduction to the Conversion of Flip-Flops


Load More