Hi everyone...quick question:
I built this little circuit that's supposed to amplify a small voltage unto a higher voltage to run a few devices...on Multisim, as I have the diagram setup (see attached) works fine, but when I put it on my circuit board....no amplification whatsoever. So my question is...
Am I supposed to do something with the unused pins? That's really the only problem I can see with the circuit.
Thanks!
I built this little circuit that's supposed to amplify a small voltage unto a higher voltage to run a few devices...on Multisim, as I have the diagram setup (see attached) works fine, but when I put it on my circuit board....no amplification whatsoever. So my question is...
Am I supposed to do something with the unused pins? That's really the only problem I can see with the circuit.
Thanks!
Attachments
-
39.9 KB Views: 46