Hey guys I was wondering if sombody cound give me a little help...
I'm about to program a propeller chip to control a micromo (faulhaber) 1624 E DC motor, but i've stalled at the first hurdle. I can't find the data sheets for it anywhere on the web, only a page listing its dimentions and attributes.
I'm looking to control the motor through pwm generated from the prop chip through a L293D driver, but the problem is there are 7 unmarked wires coming out of the motor into a junction block.
Well, one is green and seperate from the block
4 wires attached in a ribbon
2 wires not in the ribbon, which i'm assuming are for the encoder.
Does anybody know how I would identify these wires, and what I would do with them when I do?
Cheers
I'm about to program a propeller chip to control a micromo (faulhaber) 1624 E DC motor, but i've stalled at the first hurdle. I can't find the data sheets for it anywhere on the web, only a page listing its dimentions and attributes.
I'm looking to control the motor through pwm generated from the prop chip through a L293D driver, but the problem is there are 7 unmarked wires coming out of the motor into a junction block.
Well, one is green and seperate from the block
4 wires attached in a ribbon
2 wires not in the ribbon, which i'm assuming are for the encoder.
Does anybody know how I would identify these wires, and what I would do with them when I do?
Cheers
