I have an old Rode NT1 condenser Mic.
I fixed it a couple of months ago by rewiring. I'm not good at soldering, but it worked. Then it fell from the mic stand and stopped working again.
Upon inspection one of the wires had gotten loose from the circuit board.
I rewired once more but have had no luck having it working again.
I fear i might have damaged the circuit board with my sloppy soldering. (I think that it might be input 1 / power source not working)
I'll attach pictures to get your opinions.
Thank you all.
Moderator's note: The initials CB were replaced with the words circuit board by a moderator. If you intended a different meaning, please tell us using the Report button. Please do not use uncommon abbreviations, and since this is an international forum in which many useres are not native English speakers it is best to spell things out.
I fixed it a couple of months ago by rewiring. I'm not good at soldering, but it worked. Then it fell from the mic stand and stopped working again.
Upon inspection one of the wires had gotten loose from the circuit board.
I rewired once more but have had no luck having it working again.
I fear i might have damaged the circuit board with my sloppy soldering. (I think that it might be input 1 / power source not working)
I'll attach pictures to get your opinions.
Thank you all.
Moderator's note: The initials CB were replaced with the words circuit board by a moderator. If you intended a different meaning, please tell us using the Report button. Please do not use uncommon abbreviations, and since this is an international forum in which many useres are not native English speakers it is best to spell things out.
Attachments
-
2.1 MB Views: 10
-
2.5 MB Views: 10
-
1.7 MB Views: 9
Last edited by a moderator: