Hi everyone,
Please, kind souls of the circuit design world, help me answer one of both of the following:
What training materials would I need to study to design the desired circuits below
Circuit 1 (using 120V AC winch from harbor freight, this motor uses a diode bridge to convert AC to DC).
B. In momentary - press and hold the button and the motor moves forward. Release the button and motor stops. Then press and hold the button and the motor goes in reverse. Release and the motor stops. Press and hold the button and the motor goes forward.
Circuit 2
Same circuit, except a 12V “2500 lb” DC winch from harbor freight is used
Please, kind souls of the circuit design world, help me answer one of both of the following:
What training materials would I need to study to design the desired circuits below
- How specifically can I design the desired circuits below
Circuit 1 (using 120V AC winch from harbor freight, this motor uses a diode bridge to convert AC to DC).
- Operate the winch with a single push button from a remote control and allow the option to operate in momentary or latching (ideally the latching circuit will latch on the remote, so if the battery dies or the remote lost connection the winch would stop operating)
B. In momentary - press and hold the button and the motor moves forward. Release the button and motor stops. Then press and hold the button and the motor goes in reverse. Release and the motor stops. Press and hold the button and the motor goes forward.
Circuit 2
Same circuit, except a 12V “2500 lb” DC winch from harbor freight is used