I have been searching and have not found exactly what I believe I need.
Scenario: I am adding LED's to my truck
1st input is from a dashboard on/off switch
2nd input is from a signal from my courtesy lights
If either is charged the LED's should be activated. There are 12 LED's at 9 Watts each so estimated 10 Amp draw.
Question: What is the proper safe way of doing this?
I am thinking two relays, but looking for expert advice and possibly a schematic with the SPDT relay. Your help/advice is greatly appreciated.
Scenario: I am adding LED's to my truck
1st input is from a dashboard on/off switch
2nd input is from a signal from my courtesy lights
If either is charged the LED's should be activated. There are 12 LED's at 9 Watts each so estimated 10 Amp draw.
Question: What is the proper safe way of doing this?
I am thinking two relays, but looking for expert advice and possibly a schematic with the SPDT relay. Your help/advice is greatly appreciated.