I'm not very experienced with low voltage wiring but here it goes.
I have a round baler with an electric tie mechanism. I want to be able to build a setup that will let me push a button and it will run through its cycle on its own. Right now I use a DPDT switch to run it. The cycle I would like it to run is as follows:
1. motor runs approximately 8 seconds, pauses 5 seconds
2. motor switches polarity and either slowly returns back or goes on ,off, on, off approximately 10 times
3. motor switches polarity runs two seconds, pauses 5 seconds
4. motor switches poality runs three seconds, back to home position
thank you for your time, sorry for the poor terminology
I have a round baler with an electric tie mechanism. I want to be able to build a setup that will let me push a button and it will run through its cycle on its own. Right now I use a DPDT switch to run it. The cycle I would like it to run is as follows:
1. motor runs approximately 8 seconds, pauses 5 seconds
2. motor switches polarity and either slowly returns back or goes on ,off, on, off approximately 10 times
3. motor switches polarity runs two seconds, pauses 5 seconds
4. motor switches poality runs three seconds, back to home position
thank you for your time, sorry for the poor terminology