12v circuit usually draws from .3A-.7Amp but i am not drawing any current

Thread Starter

WestTron

Joined Oct 21, 2015
2
Hello, i have an ecu (electronic control unit) that i am repairing and was wondering if i could get some advice/key points to reason it is not drawing any current. The unit is recieving 12v as it should, my 5v, 8v, and 100v are all good. Any takes?

Thanks,
-West
 

Thread Starter

WestTron

Joined Oct 21, 2015
2
My fault! it is a double decker board, having only to work on one side i forgot about the other side which i disconnected. reconnected and is working properly.
Thanks though!
 
Top