Both of this graph show mosfet and but in switching mode
As i look at the graph below I notice for mosfet the drain source amplitude is higher than the gate voltage amplitude . However , bjt , collector voltage amplitude is only reach at the same amplitude of base voltage amplitude. From this...
Hi,
I have to switch a high current(DC 12V@~60A approx.) for a battery-supplied circuit.
But its on-status resistance should be as low as possible. Because you know the Ohm's Law, the I is going to increase up to even 100 amps sometimes, so a very small resistance creates a big difference.
I...
Hello, I have been build this high frequency solid state tesla coil for a while now and have tried quite a few different circuit with some success but ultimately I have fry a lot mosfets in the process, so far this is best I have came up with but I have a few problems.
1. Alot of these hfsstc...