240v

I want to upgrade my kiln to digital control. Looking at using a PID to control relay to cycle kiln on/off based on temperatures in the kiln. Would I interrupt both hots, each with its own SSR? Inputs to the SSR wired parallel from the PID? Please see attached, each hot goes to its own...

Hey I'm a NOOB trying to complete a DIY project of hooking up a thermostat to my garage heater. I am following this video... I ordered the exact contactor and transformer linked in the comments. I can't get the contactor to close. The highest voltage I have seen from the transformer is...

Hello all, I am trying to get my old lathe/mill going again (the old motor seized) and have bought a new dual cap motor with a slight increase in power. Trouble being, it will need to be reversible due to the lathe needing cw rotation, the mill needs ccw rotation (or the other way around, I...

Hi . I recently acquired a 250vac 240v to 24v transformer. Which i am going to use for a project. Just want to confirm my numbers are right. 3 things. 1)That @24v the maxium i can draw is 10a. 2) 24×10= 240watts. Would a 1a fuse on the 240v side do as suitable protection. 3) As i have a earth...

Hi All, I bought a Waeco CF110 (A) fridge second hand and have found an interesting fault I can't diagnoise. Note: The Fridge can run off both 12V and 240V. In 12V operation the fridge runs perfectly. In 240V mode once warmed up a (after a period of ~40mins), the compressor will stop for a...