Facebook
Google
GitHub
Linkedin
flux density in transformer
- Thread starter Labiva
- Start date
If its a transformer with a sinusoidal waveform supply [such as a mains transformer] - you use the most fundamental of all the transformer equations.
\(E=4.44fNAB_m\) [Volts RMS]
where
E=Applied [usually primary] rms voltage
f=frequency [Hz]
N=turns on the winding [primary] where the voltage E is applied
A=Magnetic circuit cross-sectional-area enclosed by the winding [m^2]
Bm = the maximum flux density [Tesla]
leading to
\(B_m=\frac{E}{4.44 f N A}\) [Tesla]
\(E=4.44fNAB_m\) [Volts RMS]
where
E=Applied [usually primary] rms voltage
f=frequency [Hz]
N=turns on the winding [primary] where the voltage E is applied
A=Magnetic circuit cross-sectional-area enclosed by the winding [m^2]
Bm = the maximum flux density [Tesla]
leading to
\(B_m=\frac{E}{4.44 f N A}\) [Tesla]
actually i want to build a transformer on my own. the formula for finding the primary winding of the transformer is
Np= (Ep X 10^8) / 4.44*F*A*Bm where
Np = number of primary turns.
Ep = known primary input voltage in volts.
Bm = maximum flux density in gauss.
A = effective core area in cm^2
F = input frequency in Hz.
so here both N and Bm are unknown. so how can i calculate Bm then so that i can find the number of primary windings.
The maximum flux density Bm depends very much on the material used. Mains frequency transformer steels can be operated at least to 1.5 Tesla [15,000 gauss] - and probably up to 1.7 or 1.8 Tesla depending on the core losses and magnetizing current harmonics one is willing to tolerate. Other materials like ferrites have much lower practical Bm values.
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
|
Flux Ai use for pcb design | General Electronics Chat | 9 | |
| Z | What flux do I need for Multicore soldeing wire type 365 FLUX 5 CORE | General Electronics Chat | 10 |
