...isnt working right now. Sorry. The wave goes like this:If you start at max.negative and going positive, the trace is linier to you get to about...
What value resistor and max current do you recommend?
It will have to be able to stand the full mains voltage across it and still allow enough...
Not necessarily, before digital, all wall clock motor were 1ph synchronous motors.
What is it, you are using the TB or designing your own?
The TB6600 has opto isolation, why not use the customary method using opto's?
Its a TB6600. I'm not using an off-the shelf one. Trying to design one on my own.
What is the stepper drive you are using, as already mentioned, most off the shelf drive versions use an opto isolator input for the step/dir.
Repulsion motors fell out of favour soon after that date.
I go outside and try to manually turn the shaft and listen.
From what I understand that company stopped in 1963 so it could maybe be 60+ yrs old,...
...has this feature is not obvious without opening it up.
When it runs or you turn it by hand can you detect the sound of brushes on a commutator?...
I just tried B & Y to the power source and it ran CW with the G & R tied together separate from the power source
So then I tried G & R to the...
I have never used the module or Arduino.
Hi Max. I've been using the module documentation (previously posted) until it arrives. it's something I'm slightly confused by so thought I should...
The OP chart shows the three mode options.
Tahmid's blog: Using the high-low side driver IR2110 - explanation and plenty of example...
Don't you have documentation for the module?
...to set the LEDs at a low brightness? 0.7V will give you a few % of the max brightness.
I'll check back in the morning. It is 1:30AM here and I...
...you can use already built. Check Amazon, etc. Also watch efficiency and max current, get a current rating higher than you need by say 50...
Thank You Max. I failed to mention in this post that my switching frequency is atleast 10KHz.
But I wasn't aware the op intended to make a 'million widgets' the intention was to advise him of good practices for personal projects.;)
...of ram. The PicF16877 only has 368 bytes of ram and operates at a max speed of 20mhz. Even if you could figure put how to store your...
In this example, we are given,
VCC = 12V
RL = 1.2kΩ
ICmax should be 10mA (well, never mind. Let's assume that RL is 1.3kΩ).