drc_567's Recent Activity

  1. drc_567 replied to the thread How is the odometer signal made ?.

    Check to see if the intended vehicle is equipped with a Crankshaft Position Sensor. In certain modern vehicles, the CPS is the signal...

    Oct 17, 2018 at 8:04 PM
  2. drc_567 replied to the thread I'm trying to imagine a 12vdc automotive vacuum balancing manometer.

    10 psi sounds like over range for some of the common silicon sensors like the 26PC01SMT. Could you get by with something like +/- 25...

    Oct 16, 2018 at 9:05 PM
  3. drc_567 replied to the thread I'm trying to imagine a 12vdc automotive vacuum balancing manometer.

    On the dual port gauge shown, what are the units shown on the face? ... Can't quite make out the print.

    Oct 16, 2018 at 8:42 PM
  4. drc_567 replied to the thread Automotive Trailer Wiring - Something weird is happening here..

    Try 100 uF maybe ... check that polarity is correct ... + to 12 volts, - to ground. 100 volt or 50 volt rating ... whatever is available.

    Oct 14, 2018 at 2:59 PM
  5. drc_567 replied to the thread Automotive Trailer Wiring - Something weird is happening here..

    If nothing else works, try placing an electrolytic capacitor to ground in parallel with each jeep blinker light. Maybe the blinking is...

    Oct 14, 2018 at 2:51 PM
  6. drc_567 replied to the thread Automotive Trailer Wiring - Something weird is happening here..

    ...specific wiring diagram required for a better idea of what the problem is.

    Oct 14, 2018 at 12:41 PM
  7. drc_567 replied to the thread Automotive Trailer Wiring - Something weird is happening here..

    ... Try cycling the RV Hazard Light switch a few times. That switch passes the turn signal wiring through, but likely doesn't see much...

    Oct 14, 2018 at 4:56 AM