wireless industrial device switching using 1 phase and 3 phase

Discussion in 'General Electronics Chat' started by devmania, Jan 28, 2014.

  1. devmania

    Thread Starter New Member

    Aug 22, 2010
    17
    0
    hello ,

    i want to control industrial devices using wireless (RF) technique both in single phase and three phase.
    single phase - maximum 25amps
    3 phase - maximum 32amps
    3 phase motor on/off for any load through wireless frequency 433MHz range with protection short circuit low voltage ammeter voltmeter.

    please help me to do this project.
     
    Last edited: Jan 28, 2014
  2. devmania

    Thread Starter New Member

    Aug 22, 2010
    17
    0
    can any one please suggest me any idea to start this project? or can anyone provide me some suitable source or reference regarding this project ?
     
  3. MaxHeadRoom

    Expert

    Jul 18, 2013
    10,569
    2,380
    What range? There are a few of the TX/RX units with digital decoders.
    Look for these types and ultimately you will need to switch the 1ph & 3ph probably using contactors of some kind, with over loads, depending on the nature of the load.
    From start to finish this is no mean project.
    Max.
     
    devmania likes this.
  4. devmania

    Thread Starter New Member

    Aug 22, 2010
    17
    0
    thanks a lot max.
     
Loading...