I'm new to both electronics and Eagle so I though it might be good exercise to replicate some simple circuits in Eagle to reinforce my learning of each.
Well... I didn't get far before hitting a wall. I drew a schematic of a simple pull-up resistor. My drawing is very simple a momentary switch with one leg to GND the other to a digital input pin and VCC via the pull-up resistor.
My question is this: Where do I find a "pin" termination point in Eagle? I'd like to terminate the wire going to the input pin with a nice finial but for the life of me can't find one in Eagle 6.5. Searching the web I see where earlier versions had a pin icon in the tools menu but I can't find that in 6.5.
Thanks, in advance.
Well... I didn't get far before hitting a wall. I drew a schematic of a simple pull-up resistor. My drawing is very simple a momentary switch with one leg to GND the other to a digital input pin and VCC via the pull-up resistor.
My question is this: Where do I find a "pin" termination point in Eagle? I'd like to terminate the wire going to the input pin with a nice finial but for the life of me can't find one in Eagle 6.5. Searching the web I see where earlier versions had a pin icon in the tools menu but I can't find that in 6.5.
Thanks, in advance.