wimax simulation by matlab

Discussion in 'Programmer's Corner' started by hamran, May 2, 2007.

  1. hamran

    Thread Starter Member

    Aug 21, 2006
    10
    0
    dear friends
    i think im facing some little problem here with my final graduation project....im working on wimax and i wanna simulate the project with matlab with physical layer only
    can any1 help
    thax
     
  2. thingmaker3

    Retired Moderator

    May 16, 2005
    5,072
    6
  3. Dave

    Retired Moderator

    Nov 17, 2003
    6,960
    144
    Ok, so what have you got already?

    We can help with the coding, but you must guide us with details of the project spec.

    Dave
     
  4. hamran

    Thread Starter Member

    Aug 21, 2006
    10
    0
    what i actually need is to simulate the ptoject as blocks in the matlab physical layer of wimax ( OFDM) USING matlab simulink.
     
  5. Dave

    Retired Moderator

    Nov 17, 2003
    6,960
    144
    Ok, so have you derived/designed the block-interfaces for your physical layer? If so, you would be advised to upload it so we can give advice on how to trasnlate it into Simulink. Otherwise, you are looking at creating a design for the physical layer, which is a whole different question (and quite a complex one).

    Dave
     
  6. maca

    New Member

    May 28, 2007
    1
    0
    I'm also working in the same project.I'm facing some problems with the coding.I want to implement the convolutional turbo code but I don't managed to get the caracteristic polynomial to use the convolutional encoder block. The only information I have is that the feedback branch is 0xB, one of the outputs, 0xD and the other is 0x9.
    Could anyone help me to write in matlab this polynomial?
    Thank you
     
Loading...