All About Circuits

Voltage Source Invertor

Abdul Wali

Thread Starter

Abdul Wali

Joined Mar 19, 2016
35
hi.
can someone plz help !
if An induction motor controlled using voltage source inverter (VSI) . V/f is kept constant for frequency 50Hz and below. why the breakdown torques are not constant for these frequencies. what can be the solution of this problem.
 
gerty

gerty

Joined Aug 30, 2007
1,305
What little I know about VSI, the Voltage is kept constant, not the frequency. Can you explain a little more about what you are looking for.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
R Using a plotter with RS-232C input with a voltage source (block diagram sought) Test & Measurement 11
A Why the offset of source-follower（which connected to the output of opamp as voltage buffer) will limit the op-amp output swing ？ Homework Help 0
T How and when to use a NMOS and PMOS as current source/sink and voltage source in a circuit? Analog & Mixed-Signal Design 2
SamR Resistor Voltage Divider Vs. Zener Power Source Power Electronics 4
N Voltage Source Invertor ..#2 General Electronics Chat 2
Similar threads
Using a plotter with RS-232C input with a voltage source (block diagram sought)
Why the offset of source-follower（which connected to the output of opamp as voltage buffer) will limit the op-amp output swing ？
How and when to use a NMOS and PMOS as current source/sink and voltage source in a circuit?
Resistor Voltage Divider Vs. Zener Power Source
Voltage Source Invertor ..#2

You May Also Like

Top