Using the EG8010 IC and the EGS002 board: Problems, quirks, flaws

Discussion in 'Power Electronics' started by Ludens, Sep 15, 2016.

  1. Ludens

    Thread Starter New Member

    Nov 12, 2014
    1
    0
    Hi all,

    I'm embarked on a project to build a high quality, reliable, pure sine wave inverter, rated at 220V, 4kW continuous output, with 48V input. Over the last few days I have been playing with an EGS002 SPWM driver board, that has the EG8010 SPWM chip on it. I found several quirks, troubles, problems, that raise doubts as to whether it is a good idea to use this board and even this IC.

    Is there anybody around here who has used it, tried it, tested it, and would like to discuss these issues?

    Manfred
     
Loading...