Hi all,
I've bought a PIC18F4550 USB Development Board (this board supports " Direct In-Circuit Program Download with a USB Connection") and I'm going to use MPLAB IDE v8.10. Could you please show me how to configure USB connection with my board in my MPLAB ?
Thank you!

 

Hm... From where? If the firmware is compatible with PICDEM FS from Microchip, then you can use the USB downloader from Microchip. Download the USB Framework from http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=2680&dDocName=en537044 and then install the driver and PICDEM FS demo program. There is a downloader included with the demo program.

If not compatible, there should be a program included when you purchased the board.