Understand Pinout for the FDC6301N

Discussion in 'General Electronics Chat' started by Sparky49, Jun 21, 2013.

  1. Sparky49

    Thread Starter Active Member

    Jul 16, 2011
    834
    417
    Hi everyone,

    I'm thinking of using a FDC6301N to act as an I2C level converter in a circuit I'm designing.

    It's not in the Eagle libraries, so I went to the datasheet to investigate the pinout, however, I cannot fathom what pins on the package connect to the schematic pinout.

    Here is the offending datasheet:

    http://www.farnell.com/datasheets/11836.pdf

    Can anyone make out what is supposed to connect to what? I could be missing out on some convention, but I wouldn't think that was the case.

    Thanks very much,

    Sparky
     
  2. praondevou

    AAC Fanatic!

    Jul 9, 2011
    2,936
    488
    The first page shows what is connected to what. 1,6,5 is GDS of one FET and 3,4,2 is GDS of the second one.

    Or is your question how to identify pin 1? There is supposed to be a dot on the package where pin 1 is.
     
    Sparky49 likes this.
  3. Sparky49

    Thread Starter Active Member

    Jul 16, 2011
    834
    417
    Thanks, I think it has just clicked.

    A bit of a 'duh' moment. :)

    Thanks again.
     
Loading...