For this project I was hoping to create three wires or antennas for the X-Y-Z right hand system to use for directX. Each Antenna would have their seperate FETS then go into arduino to save to SD Disk or perhaps stream real live information.

For instance, say if the device is located center of a room. Say the room is about 6 x 7 x 12 feet.

How would I be able to calculate the intensity on each antenna so I would have a rough estimated floating point like 1.0f, -5.0f, 2.0f bring in DirectX?

Is it even possible to estimate the amount of intensity of electrostatic charge potential of each three antennas?

Thanks for your input!

 

The idea is to be able to represent visually static electricity potential by 3D Means - so there has to be a way to detect the potential intensity, correct?