Transformer selection for Power Supply

Discussion in 'General Electronics Chat' started by europlugs, Jul 10, 2016.

  1. europlugs

    Thread Starter New Member

    Jun 9, 2016
    1
    0
    I'm designing the power supply to fit a commercial product I'm developing. I went with 85-265V, 50-60Hz input and 12V, 1A output to start (the load will vary based on what the user attaches to the power supply). I have been using the board mount CUI power modules for the alpha prototype, but the main problems I have with them (from the perspective of mass) are cost (both in terms of unit and assembly time into the product) and form factor (could use a little less height). The ideal solution I'm looking for is to combine my application board with the power supply.

    Mod edit: moved to new thread from here:
    http://forum.allaboutcircuits.com/threads/transformer-selection.50096/#post-1018535
     
Loading...