After some success with my TDA1517 amplifier circuit, I decided to try the TDA1519C. I breadboarded both the stereo and the BTL sample circuits on page 10 of the attached datasheet. In both cases, I could hear the audio signal faintly in the speaker(s), but there was very loud and irregular popping noise. The popping would stop only when I decreased the input voltage to an extremely low level. As I increased the input, the popping would get louder and more frequent, but still had no discernable pattern. I tried it with two different IC's and got the same results.
Any ideas what the problem might have been?
Any ideas what the problem might have been?
Attachments
-
1.1 MB Views: 9
-
52.6 KB Views: 26