All About Circuits

Strain gauges and typical millistrain

hunterage2000

Thread Starter

hunterage2000

Joined May 2, 2010
487
Hi,

Im trying to test a signal conditioing circuit for a strain gauge bridge full bride setup. I am going test the circuit with two ac signal inputs to replicate the bridge voltage. Can anyone tell me typical ranges of millistrain so I can change the values of the four resistors to set the bridge voltages?
Apparently it ranges only in a few millistrains.
I am using four 350ohm strain gauges.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
kalemaxon89 Sensitivity and Resolution of Strain Gauges with the ADC Homework Help 0
S Multiplexing 16 strain gauges with only one Wheatstone bridge and one IA Analog & Mixed-Signal Design 32
Rocky_circuits Multiplex signals from strain gauges Analog & Mixed-Signal Design 13
L Strain Gauges - Full Bridge Combinator and Amplification Test & Measurement 21
A Strain Gauges affected by temperature or humidity? Test & Measurement 11
Similar threads
Sensitivity and Resolution of Strain Gauges with the ADC
Multiplexing 16 strain gauges with only one Wheatstone bridge and one IA
Multiplex signals from strain gauges
Strain Gauges - Full Bridge Combinator and Amplification
Strain Gauges affected by temperature or humidity?

You May Also Like

Top