Hi guys,
So I have a project that I'm working on using a micro-controller to give input to an IGBT driver. The driver that I am using is the MC33153.
My question is why am I only getting a mV signal from the output pin?
I'm providing about 16V to the Vcc input and connecting Vee and the kelvin gnd inputs to ground. I'm also providing a TTL square wave to the input pin.

i am working at same gate driver mc33153
can help me by send your project or a picture for results?


Mods Note:
You were replied to a old thread that we called necropost, the TS(Thread Starter) was leave for 2 years maybe he never return.
This thread was split from -- IGBT driver.

 

Pdf attached