Simple Cell Phone Jammer - simulation problem

Discussion in 'The Projects Forum' started by whycanot, May 10, 2012.

Thread Status:
Not open for further replies.
  1. whycanot

    Thread Starter Member

    May 22, 2011
    54
    0
    im an electronic engineering student. currently doing my FYP for degree.
    i have chosen a telecommunication system project which i have really limited knowledge on it.
    the topic is "cell phone jammer".
    to block GSM 900 and GSM 1800 for my country.

    i have searched a lot in the forum. but most of document attached is not suitable for me. either different GSM or circuit is far too complicated or hardware is too hard to find or ...

    problems in this post:
    1) what software can I use to do simulation?
    2) what part should I simulate on? what result/data is needed or important before build on pcb?

    thanks in advanced for all seniors which reading and reply this.
     
  2. bertus

    Administrator

    Apr 5, 2008
    15,647
    2,346
    Hello,

    I am closing this thread as it violates AAC policy and/or safety issues.

    Quote:
    6. Restricted topics. The following topics are regularly raised however are considered “off-topic” at all times and will results in Your thread being closed without question:

    • Any kind of over-unity devices and systems
    • Automotive modifications
    • Devices designed to electrocute or shock another person
    • LEDs to mains
    • Phone jammers
    • Rail guns and high-energy projectile devices
    • Transformer-less power supplies
    This comes from our Tos:
    Terms of Service

    Bertus
     
Loading...
Thread Status:
Not open for further replies.