im an electronic engineering student. currently doing my FYP for degree.
i have chosen a telecommunication system project which i have really limited knowledge on it.
the topic is "cell phone jammer".
to block GSM 900 and GSM 1800 for my country.
i have searched a lot in the forum. but most of document attached is not suitable for me. either different GSM or circuit is far too complicated or hardware is too hard to find or ...
problems in this post:
1) what software can I use to do simulation?
2) what part should I simulate on? what result/data is needed or important before build on pcb?
thanks in advanced for all seniors which reading and reply this.
i have chosen a telecommunication system project which i have really limited knowledge on it.
the topic is "cell phone jammer".
to block GSM 900 and GSM 1800 for my country.
i have searched a lot in the forum. but most of document attached is not suitable for me. either different GSM or circuit is far too complicated or hardware is too hard to find or ...
problems in this post:
1) what software can I use to do simulation?
2) what part should I simulate on? what result/data is needed or important before build on pcb?
thanks in advanced for all seniors which reading and reply this.