Assalam o alaikum,
I want to control a servo motor of futaba fps-148 through parallel port using turbo c. I want to know that do i have to build a servo motor driver or i can simply use the data pins d0-d8 of parallel port to control the servo?

Regards

 

A driver is required..
Google has TONS of results for driving servo motors via a driver off a parallel port

 

can u help me find an appropriate driver and i have heard that it can be run without driver also?

 

I wouldn't run any motor from a parallel port without a driver.. You are just asking for trouble doing that..
Here is something I found on Google..
http://elk.informatik.fh-augsburg.d...v4/rtlinux/rtutorial-2.0/doc/ex08_rcservo.htm

 

thanks for the link,i'll check it out and i will be using turbo c for the programming!