Sequentcial Signal Light Driver?

Discussion in 'The Projects Forum' started by Roddy Wayne, Apr 27, 2015.

Thread Status:
Not open for further replies.
  1. Roddy Wayne

    Thread Starter New Member

    Apr 27, 2015
    1
    0
    Hello,
    I'm new to this group and I'm looking for some help. I own an old 1963 Mercury Comet and would like to put
    Sequential Signal Lights on it. I've written a program in PIC BASIC PRO that I think should work but, the problem I'm having is finding suitable drivers for the #1157 bulbs that are currently being used with their screw
    shells being grounded to the car's body so, High Side Drivers must be used. Each 1157 bulb draws about 2.5 Amps.
    Thanks for your help!
    Rod
     
  2. bertus

    Administrator

    Apr 5, 2008
    15,646
    2,345
    Hello,

    I am closing this thread as it violates AAC policy and/or safety issues.

    Quote:
    6. Restricted topics.

    The following topics are regularly raised however are considered “off-topic” at all times and will results in Your thread being closed without question:

    • Any kind of over-unity devices and systems
    • Automotive modifications
    • Devices designed to electrocute or shock another person
    • LEDs to mains
    • Phone jammers
    • Rail guns and high-energy projectile devices
    • Transformer-less power supplies
    This comes from our Tos:
    Terms of Service
    There will be enough sites where automotive questions can be discussed :
    Member selected automotive forums

    Bertus
     
Loading...
Thread Status:
Not open for further replies.